Dell PowerEdge C6220 - Manual (Page 232)

232 | Installing System Components
Figure 3-57. Removing and Installing the System Board
1 screw (8) 2 system board
3 system-board assembly
Installing a System Board
1 Unpack the new system board.
2 Holding the system board by the edges, slide the system board into the
system-board assembly.
3 Replace the eight screws to secure the system board to the system-
board assembly.
4 Transfer the processors to the new system board. See “Removing a
Processor” on page 162 and “Installing a Processor” on page 164.
5 Remove the memory modules and transfer them to the same locations
on the new board. See “Removing the Memory Modules” on page 225
and “Installing the Memory Modules” on page 227.
6 Replace the heat sinks. See “Installing the Heat Sink” on page 161.
7 Install the expansion-card assembly. See “Installing the Expansion
Card” on page 172.