Dell PowerEdge C6220 - Manual (Page 117)

Using the System Setup Program | 117
Token Setup option Description
0137 Embedded
SATA Controller Enables the SATA controller. Sets the device class code as
IDE and uses PCI IRQ (referred as Native mode). This
token applies to the first on-board SATA controller.
0138 Embedded
SATA Controller Enables the SATA controller. Sets the device class code as
SATA and sets up the AHCI BARs and registers. This
token applies to the first on-board SATA controller.
0139 Embedded
SATA Controller Enables the SATA controller. Sets the device class code as
RAID and executes the RAID Option ROM. This token
applies to the first on-board SATA controller.
013E
Memory
Remapping
(3GB~4GB)
Memory remapping relocates memory space behind PCI
hole to the space above 4G with this feature disabled.
013F
Memory
Remapping
(3GB~4GB)
Memory remapping relocates memory space 3G~4G to
the space above 4G with this feature enabled.
0140
Execute-Disable
(XD) Bit
Capability When disabled, Intel processors that support the
eXecute Disable (XD) feature will not report the
support to the operating system.
0141 Execute-Disable
(XD) Bit
Capability When enabled, Intel processors that support the eXecute
Disable (XD) feature will report the support to the
operating system. If the operating system supports this
extended paging mechanism, it will provide some
protection against software viruses that exploit buffer
overflows.
014A Virtualization
Technology This feature will allow the users to disable the VT
technology in applicable processors. If disabled, the VT
feature is unusable in any OS.
014B Virtualization
Technology This feature will allow the users to enable the VT
technology in applicable processors.
014E
External USB
PORT1
This feature will allow the users to electrically disable the
external USB port1.
014F External USB
PORT1 This feature will allow the users to electrically enable the
external USB port1.
0168 Max CPUID
Value Limit
Some OS's (NT4) will fail if the value returned in EAX
is > 3 when CPUID instruction is executed with EAX=0.
This setting disables the 3 or less.