Rockwell Automation FactoryTalk Report Expert User Guide - Manual (Page 92)

Chapter 6 Understanding Parameter Sets
92 Rockwell Automation Publication RPTEXP-UM001H-EN-P-June 2014
operation — data must match all defined filters to be included in the
report.
TIP
The fields in the filtering parameter allow you to select multiple field
values for filtering.
Use the filtering field and value to limit the information returned to
a report. The field you select will dictate how the value is to be
entered—some fields allow you to type any value in the parameter,
while other fields require selection from a list of possible values. The
condition for all field and value pairs is "equals." If more than one
filter is specified, the filter items are joined by a logical AND.
You can filter report data using the following filters:
This filter: Filters by:
Part Id The ID of the part that was being produced when the event
occurred.
Part Description The description of the part that was being produced when
the event occurred.
Ideal Cycle Time The time required for one part to pass through a work cell
under ideal conditions.
Event Name The name of the event.
Event Category The category of the event.
Event Severity The numeric severity level assigned to the event.
Event Reason Code The numeric code representing the event reason.
Event Reason The string value representing the event reason.
Event During Scheduled
Time Information whether the event occurred during the
scheduled time.
Record State The numeric state of the database record.
Event Start Num The numeric value collected at the start of the event.
Event End Num The numeric value collected at the end of the event.
Event Is Fault Information on whether the event is used for Faults metrics.
Event Has Comment The event that includes or does not include comments.
State Name The machine state. This field is color coded.
Selecting the Filtering Field
and Value