Konica Minolta bizhub 282 - Manual (Page 358)

Utility mode 11
362/282/222 11-17
Utility mode
Ch
apt
er
11
Crease/Center Staple
2
Note
The “Crease/Center Staple” parameter appears only if optional finisher or
saddle stitcher is installed.
Default Screen
2
Note
The names of parameters and settings may be different when fax kit is
installed.
!
Detail
The Default LCD Screen setting specifies the default screen when the au-
tomatic panel reset operation is performed or the machine is turned off,
then on again.
In order to check the setting after it has been changed, turn the machine
off with the main power switch, and then wait about 10 seconds before
turning it on again. The machine may not operate correctly if it is turned
on immediately after being turned off. For details on turning the machine
off and on, refer to “Turning on the main power and the auxiliary power”
on page 2-22.
Tab Parameter Description Default setting
5/6 Crease/
Center Staple Specify the crease and center staple po-
sition for each paper size.
Select a paper size to be set, and then
touch [Enter].
• Crease:
Specify the position of the fold (be-
tween -10 and +10).
• Center Staple:
Specify the position of the center sta-
ple (between -10 and +10).
Crease: 0
Center Staple: 0
Tab Parameter Description Default setting
6/6 Default
Screen Default
LCD
Screen Select one of the following as the
mode screen given priority.
Copy, E-Mail, Scanner Copy
Default E-
mail
Screen Select one of the following as the
Fax mode screen given priority.
One-Touch, Search, Address In-
put, Index One-Touch