Konica Minolta bizhub 282 - Manual (Page 188)

Additional copy operations 4
362/282/222 4-9
Addit
ion
al copy op
era
tions
Chapter 4
4
Touch the button for the program number where a program is to be
registered.
– If a program has not yet been registered with the program number
button that is pressed, the empty icon disappears from the number
button to indicate that a program is registered with it.
– If a program has al-
ready been regis-
tered with the
program number
button that is
pressed, a message
appears, requesting
confirmation to over-
write the program. To
overwrite the pro-
gram, touch [Yes],
and then touch [En-
ter]. To cancel the registration, touch [No], and then touch [Enter].
? What if programs have already been registered to all of the program
numbers?
% If there are no program numbers where no program has been reg-
istered yet, the program registered at a program number will be
overwritten. To check the copy program settings before overwriting
it, refer to “Checking the copy settings (Mode Check)” on page 4-2.
!
Detail
To stop registering the program, press the [Reset] key or the [Mode Mem-
ory] key. No matter which screen is displayed, the registration is can-
celled.
No program registered Program registered