Konica Minolta bizhub 282 - Manual (Page 185)

4 Additional copy operations
4-6 362/282/222
Addit
ion
al copy op
era
tions
Chapter 4
6
In the Proof copy screen,
change the copy set-
tings as desired.
– The Finishing set-
tings appear in the
Proof copy screen
only if they have
been specified for
the job being
proofed. If the copy
settings cannot be
changed, stop print-
ing the proof copy. Next, press the [Reset] key to cancel the copy
settings, and then specify the desired settings.
7
Press the [Proof Copy]
key to print another
proof copy.
– If copying stops
while the Proof copy
screen is displayed
or while changing
settings after the
proof copy was print-
ed, press the [Reset]
key. A screen for
stopping the job ap-
pears. Select the job to be deleted to delete the job.
– To stop the proof copy while scanning or printing, perform the op-
eration described in “Stopping/deleting a job” on page 3-63.
8
Press the [Start] key.
The specified copy settings are queued as a job.
2
Note
The number of copies printed for the proof copy is included in the number
of copies that are specified. If the setting was changed, use the keypad
to enter the number copies.