ADTRAN Atlas 550 - Manual (Page 180)

Chapter 12. Updating Firmware
12-4 ATLAS 550 User Manual 61200305L1-1
Status Messages During Upload
During the TFTP upload process, various status messages display in Current
Update Status to indicate progress. Table 12-1 describes these messages.
Instructions for Updating Firmware Usin g TFTP
Step Action
1 Using a Telnet program, log in to ATLAS 550.
2
Select S YSTEM U TILITY / U PDATE F IRMWARE (see Figure 12-2).
Figure 12-2. Update Firmware Menu Interface
3
Move the cursor to M ODULE S LOT , and press Enter . Select the
appropriate module slot to update. To update multiple modules of
the same type, select A
LL M ODULES OF A T YPE from M ODULE
S LOT .
(Only upgradable modules are displayed as choices for M ODULE
T YPE when updating A LL M ODULES OF A T YPE in the ATLAS 550.)
4 Select TFTP for the T RANSFER M ETHOD .
5
Enter into TFTP S ERVER IP A DDRESS , the IP address of the
network server that was recorded earlier.
6
Enter into TFTP S ERVER F ILENAME , the full path name and
filename of the update file that was recorded earlier.
7
From R ESTART S CHEDULE , select the time for the module to
perform a restart after completing the update process (see Restart
Schedule on page 6-18).
8
View C URRENT U PDATE S TATUS to verify the progress of the
current firmware update or any errors encountered during the
download process (see
Current Update Status on page 6-19).
9
Select B EGIN F IRMWARE U PDATE to start the update process. Enter
Y to confirm the transfer and to set up the module to receive the
TFTP upload.
10
To update additional modules, begin at step 3 and repeat this
process.