ADTRAN Atlas 550 - Manual (Page 172)

Chapter 11. Dial Plan
11-30 ATLAS 550 User Manual 61200305L1-1
R ANDOMIZE T IMER
Write security: 3; Read security: 5
Enables/disables random delay added to the redial timer to avoid glare.
R ETRY C OUNT
Write security: 3; Read security: 5
Defines the number of redials to attempt.
O UTGOING C ALLER ID
Write security: 3; Read security: 5
Defines the presentation of the calling party number for this endpoint.
S OURCE ID
Write security: 3; Read security: 5
Used to simplify the creation of a
D IAL P LAN in applications where the crite-
rion for switching calls to a certain endpoint is a function of which endpoint
originated the call. For further details, see Source ID on page 11-14.
R OUTE I NCOMING C ALL
Write security: 3; Read security: 5
Used to define the method which incoming calls are associated to the
packet endpoints. This item can have three options:
U SING I NCOMING N UM
Endpoint selection based on the incoming number.
U SING C ALLING P ARTY N UM
Selection based on the Call ID as presented by the calling party. If this
option is selected, the
C ALL P ARTY N UMBER field is made available to
the interface configuration. This number allows you to configure the
calling part number used to select this packet endpoint.
C ALL R OUTING T ABLE
Read security: 5
This table is only visible if
G ROUP is selected in the P RT /PEP field. The table
format changes, based on the selected routing option. See Figure 11-9,
below and Figure 11-10 on page 31. For each case,
C ALL P ARAMS contain
O UTDIAL # , C ALLER ID, and S OURCE ID .
Figure 11-9. Call Routing Table for Routing Using Incoming Number