ADTRAN Atlas 550 - Manual (Page 170)

Chapter 11. Dial Plan
11-28 ATLAS 550 User Manual 61200305L1-1
CONNECTING PACKET ENDPOINTS IN FRAME RELAY
After packet endpoints are created, they must be connected to a physical
port. You can connect the endpoints using either the
D EDICATED M AP (see
Chapter 10) or the D IAL P LAN . As described here, the D IAL P LAN associates a
phone number with the endpoint.
You can enter two types of packet-switched endpoints into the D IAL P LAN :
Packet Endpoints ( P KT E NDPT ) and Packet Voice ( P KT V OICE ). See Figure 11-5.
When using P KT E NDPT , endpoints are entered via U SER T ERM . When using
P KT V OICE , endpoints are entered via N ETWORK T ERM or U SER T ERM . (See al-
so, Menus for Network Termination on page 11-33 and Menus for User Termina-
tion on page 11-34.)
Figure 11-5. Dial Plan Menu for Endpoints
P KT E NDPT To facilitate dial-up packet services, the ATLAS 550 D IAL P LAN supports
packet endpoints which must be entered in the U SER T ERM menu. The U SER
T ERM menu includes S LOT /S VC , P ORT /PEP , S IG , I N #A CCEPT , O UT #R EJ , and
I FCE C ONFIG .
S LOT /S VC Write security: 3; Read security: 5
Selects the service. Select
P KT E NDPT .
P ORT /PEP Write security: 3; Read security: 5
Accepts the packet endpoint you wish to configure. Select from a specific
packet link that was configured with the
P ACKET M ANAGER menus or select
G ROUP (see Figure 11-6 ). The G ROUP option allows you to define a hunt group.
The interface configuration ( I FCE C ONFIG ) parameters vary, depending on
whether a specific packet link (endpoint) or the G ROUP option is selected.