ADTRAN Atlas 550 - Manual (Page 150)

Chapter 11. Dial Plan
11-8 ATLAS 550 User Manual 61200305L1-1
S ECONDARY S EARCH
The same accept rules apply for all secondary number searches as for pri-
mary searches.
D ATA 64K,
D ATA 56K,
A UDIO , S PEECH
Write security: 3; Read security: 5
Reflects the attached user equipment (typically a TA) bearer capability. If
the attached TA can only handle digital calls, then a voice call sent to this
endpoint would be rejected.
T REAT C ALL A S Allows the incoming call to be treated as the selected call type, regardless of
the actual incoming call type. The default selection,
A S R ECEIVED , effec-
tively disables the feature by using the actual call type. Other options
include
D ATA 64K and D ATA 56K .
O UT #R EJ Write security: 3; Read security: 5
Defines the parameters for outgoing calls that ATLAS 550 will not send to
the Network.
R EJECT N UMBER Designates which numbers this particular endpoint will not pass on toward
the Network (PSTN). Use when the outgoing call filter is different for differ-
ent users. The wild cards are identical to the
O UTGOING C ALL A CCEPT wild
cards. If desired, each User termination port can be set to reject different
numbers.
D ATA 56K,
D ATA 64K,
A UDIO , S PEECH
Rejects outgoing calls based on call type. For example, setting the reject
number to $, Digital 56/64 to enabled, and Audio and Speech to disabled,
rejects all digital calls while not rejecting analog calls.
I FCE C ONFIG Sets configuration parameters for the endpoint. These parameters vary by
the type of port selected. For detailed information on the interface configu-
ration, see Interface Configurations on page 11-10.
[0,1]-$ rejects all long distance calls, but only for this User
termination. If permitted in the Network termination endpoint, this
user could not dial long distance numbers while other users could.
This list may remain blank if the Accept List meets desired filtering.
The Call Reject list takes precedence over the Call Accept list.