ADTRAN Atlas 550 - Manual (Page 164)

Chapter 11. Dial Plan
11-22 ATLAS 550 User Manual 61200305L1-1
S OURCE ID Write security: 3; Read security: 5
Simplifies the creation of a
D IAL P LAN in applications where the criterion for
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
• Default value = 0. The default ID for all endpoints is 0 and all accept
numbers is 0. With default values, all calls are routed based only on the
dialed number.
• Multiple endpoints can have the same S OURCE ID .
• When creating the C ALL A CCEPT list, specify a S OURCE ID (s) as well as a
dialed number or range of dialed numbers to accept.
Example:
An application requires that all calls that originate from Port 1 of the
ATLAS 550 in Slot 1 be switched to Port 2 of that same module. Assign a
unique Source ID (e.g. 7) to Port 1 of the module, and then configure Port 2
to only accept calls from that unique Source ID (7).
D IAL ON O FFHOOK Write security: 3; Read security: 5
Defines a number that is automatically sent to the switchboard when a call
on this endpoint goes off hook.
DUAL NX56/64 MODULE: USER TERMINATION
When you are working in the U SER T ERM section of the D IAL P LAN menu, and
the S LT is defined as V35N X -2 , the following Interface Configuration options
are available:
S TRIP MSD does not affect C ALL A CCEPT criteria. All of the digits
(including the MSDs that are subsequently stripped) are used as
accept criterion.
The Dial on Offhook number must be specific (i.e., no "wild cards").
The Dual Nx56/64 can only serve as a U SER T ERMINATION
endpoint.