Allied Telesis AT-S63 - Manual (Page 850)

Chapter 37: Management Access Control List
850 Section VIII: Management Security
Deleting an ACE
To delete an ACE, you need to know its details, such as its IP address,
mask, protocol, and interface. The management software prompts you for
this information when you delete it. You can simplify this procedure by first
displaying the contents of the Management ACL and jotting down on
paper the specifics of the ACE you want to delete. That way you will have
the information when the management software prompts you for it.
Note
If you are managing the switch from a Telnet management session
and the management ACL is active, your management session will
end and you will be unable to reestablish it if you delete the ACE that
specifies your management workstation.
To delete an ACE, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 7 to select Management
ACL.
The Management ACL Configuration menu is shown in Figure 290 on
page 846.
3. From the Management ACL Configuration menu, type 3 to select
Delete Management ACL Entry.
The following prompt is displayed:
Enter the IP Address:
4. Enter the IP address for the ACE you want to delete.
The following prompt is displayed:
Enter the Mask:
5. Enter the mask of the ACE.
This prompt is displayed:
Enter the Protocol [TCP]:
6. Enter TCP.
This prompt is displayed:
Enter the Interface [TELNET/WEB/ALL]: