Allied Telesis AT-S63 User Manual
Page 738

Chapter 31: 802.1x Port-based Network Access Control
738
Section VII: Port Security
The Configure Authenticator Port Access Parameters menu is shown
in Figure 259.
Figure 259. Configure Authenticator Port Access Parameters Menu
6. Adjust the following parameters as necessary.
1 - Supplicant Mode
This parameter can take the following values:
Single: Configures an authenticator port to accept only one
authentication. This supplicant mode should be used together with
the piggy-back mode. When an authenticator port is set to the
Single supplicant mode and the piggy-back mode is disabled, only
the one client who is authenticated can use the port. Packets from
or to other clients on the port are discarded. If piggy-back mode is
enabled, other clients can piggy-back onto another client’s
authentication and so be able to use the port.
Multiple: Configures the port to accept up to 20 authentications.
Every client using an authenticator port in this supplicant mode
must have a username and password combination.
Note
For addition information on the authenticator modes, refer to
“Authenticator Ports with Single and Multiple Supplicants” on
page 724.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager
11:20:02 02-Mar-2005
Configure Authenticator Port Access Parameters
Configuring Port 3
1 - Supplicant Mode .......... Single
2 - Port Control ............. Auto
3 - Quiet Period ............. 60 Seconds
4 - TX Period ................ 30 Seconds
5 - Reauth Enabled ........... Enabled
6 - Reauth Period ............ 3600 Seconds
7 - Supplicant Timeout ....... 30 Seconds
8 - Server Timeout ........... 30 Seconds
9 - Max Requests ............. 2
A - Control Direction ........ Both
B - Piggyback Mode ........... Disabled
R - Return to Previous Menu
Enter your selection?