Allied Telesis AT-S63 - Manual (Page 803)

AT-S63 Management Software Menus Interface User’s Guide
Section VIII: Management Security 803
Deleting a Certificate
The procedure in this section deletes a certificate from the certificate
database. Please note the following before performing this procedure:
ˆ Deleting a certificate from the database does not delete it from the
switch. It continues to reside in the AT-S63 file system. To completely
remove a certificate from the switch, you must also delete it from the
file system. For instructions, refer to “Copying a System File” on
page 215.
ˆ You cannot delete a certificate from the database if you specified its
corresponding encryption key as the active key in the web server
configuration. The switch will consider the certificate as in use and will
not allow you to delete it. You must first configure the web server with
another encryption key pair for a different certificate. For instructions,
refer to “Configuring the Web Server” on page 753.
This procedure starts from the X509 Certificate Management menu. If you
are unsure how to access the menu, perform steps 1 to 4 in the procedure
“Adding a Certificate to the Database” on page 797.
To delete a certificate from the certificate database, perform the following
procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 87 on page 291.
2. From the Security and Services menu, type 7 to select Keys/
Certificates Configuration.
The Keys/Certificates Configuration menu is shown in Figure 266 on
page 767.
3. From the Keys/Certificate menu, type 3 to select Public Key
Infrastructure (PKI) Configuration.
The Public Key Infrastructure (PKI) Configuration menu is shown in
Figure 272 on page 794.
4. From the Public Key Infrastructure (PKI) Configuration menu, type 2 to
select X509 Certificate Management.
The X509 Certificate Management menu is shown in Figure 273 on
page 794.
5. From the X509 Certificate Management menu, type 3 to select Delete
Certificate.