Allied Telesis AT-S63 - Manual (Page 298)

Chapter 14: Classifiers
298 Section II: Advanced Operations
Deleting All Classifiers
This procedure deletes all classifiers from the switch. To delete individual
classifiers, refer to “Deleting a Classifier” on page 297.
Note
You cannot delete all classifiers if any of them belong to an ACL or
QoS policy.You must first remove all classifiers from their ACL and
policy assignments before performing this procedure.
To delete all classifiers from the switch, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 87 on page 291.
2. From the Security and Services menu, type 1 to select Classifier
Configuration.
The Classifier Configuration menu is shown in Figure 88 on page 292.
3. From the Classifier Configuration menu, type P to select Purge
Classifiers.
Caution
No confirmation prompt is displayed. All classifiers are immediately
deleted from the switch.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.