Allied Telesis AT-S63 - Manual (Page 220)

Chapter 11: File System
220 Section II: Advanced Operations
Displaying System Files
Use this procedure to display a list of the system files currently stored
either in the flash memory of the switch or on a compact flash card. For
information about shortcuts for specifying file names, see “File Naming
Conventions” on page 205.
Listing All Files To display a list of the system files stored in flash memory as well as on a
compact flash card (if the switch supports this and a compact flash card is
inserted in the slot), perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown Figure 4 on page 54.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7 on page 61.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 61 on page 208.
4. From the File Operations Menu, type 8 to select List Files.
The following prompt is displayed:
Enter file name pattern to list:
5. Enter a boot configuration file name or pattern using the wildcard “*”.
Below are examples of how to use the wildcard to display different
files.
To display a list of all the files stored both in flash memory and on a
compact flash card in the same switch, enter:
*.*
To display a list of the certificate files, enter:
*.cer
To display a list of the boot configuration files, enter:
*.cfg
To display a list of the key files, enter:
*.key