Allied Telesis AT-S63 - Manual (Page 536)

Chapter 23: Spanning Tree and Rapid Spanning Tree Protocols
536 Section V: Spanning Tree Protocols
4. If you selected STP as the active spanning tree protocol, go to
“Configuring STP” on page 537 for further instructions. If you selected
RSTP, go to “Configuring RSTP” on page 543. Multiple Spanning Tree
Protocol (MSTP) is described in Chapter 24, “Multiple Spanning Tree
Protocol” on page 553.
Note
After you have configured the spanning tree parameters, perform
steps 5 through 7 to enable spanning tree.
5. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
The following prompt is displayed:
Enter new value (E-Enable, D-Disable):
6. Type E to enable spanning tree or D to disable it. The default is
disabled.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.