Allied Telesis AT-S63 - Manual (Page 237)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 237
The following message is displayed:
Getting the file from Remote TFTP Server - Please wait
...
8. If you have not already done so, start the TFTP server software.
After the switch has downloaded the image file, the following message
is displayed:
File received successfully!
After receiving the file, the switch compares the version numbers of the
new image file that you just downloaded against the file already in the
application block on the switch. If the new image file has an earlier or
the same version number as the file in the switch’s application block, it
cancels the update process. If the new image file has a newer version
number, the switch writes the file to the application block portion of
flash memory and then resets.
Caution
The switch does not forward any network traffic while writing the
image to flash and during the reset process. This can take several
minutes to complete. Some network traffic may be lost.
This completes the procedure for downloading a new AT-S63 image
file onto a switch from a remote management session.