Allied Telesis AT-S63 - Manual (Page 493)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 493
ˆ “Deleting an SNMPv3 Target Parameters Table Entry” on page 496
ˆ “Modifying an SNMPv3 Target Parameters Table Entry” on page 497
Creating an
SNMPv3 Target
Parameters Table
Entry
To create an entry in the Configure SNMPv3 Target Parameters Table,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 430. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 148 on page
431.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Parameters Table menu.
The Configure SNMPv3 Target Parameters Table menu is shown in
Figure 161.
Figure 161. Configure SNMPv3 Target Parameters Table Menu
3. To create an SNMPv3 Target Parameters Table, type 1 to select Create
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Parameters Name:
4. Enter a name of the Target Parameters.
Enter a value of up to 32 alphanumeric characters.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure SNMPv3 Target Parameters Table
Target Parameters Name ... host125parm
Message Processing Model . v3
Security Model............ v3
Security Name ............ murthy
Security Level ........... AuthPriv
Storage Type ............. NonVolatile
Row Status ............... Active
1 - Create SNMPv3 Table Entry
2 - Delete SNMPv3 Table Entry
3 - Modify SNMPv3 Table Entry
U - Update Display
R - Return to Previous Menu
Enter your selection?