Allied Telesis AT-S63 - Manual (Page 846)

Chapter 37: Management Access Control List
846 Section VIII: Management Security
Enabling or Disabling the Management ACL
This procedure enables and disables the management ACL. When
enabled, only those management stations specified in the ACL are
allowed to manage the switch remotely using the Telnet application
protocol or a web browser. When the feature is disabled, the management
software on the switch can be accessed remotely from any management
workstation.
Note
Do not activate the management ACL until you have specified the
access control entries (ACEs). Otherwise, the switch will discard all
remote management packets, making it impossible for you to
remotely manage the unit from a Telnet or web browser
management session. For instructions on how to add ACEs, refer to
“Adding an ACE” on page 848.
To enable or disable the Management ACL, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 7 to select Management
ACL.
The Management ACL Configuration menu is shown in Figure 290.
Figure 290. Management ACL Configuration Menu
3. Type 1 to select Management ACL Status and toggle the selection to
either Enabled or Disabled. The default setting is disabled.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Management ACL Configuration
Configuring Management ACL
1 - Management ACL Status ........... Disabled
2 - Add Management ACL Entry
3 - Delete Management ACL Entry
4 - Display All Management ACL Entries
R - Return to Previous Menu
Enter your selection?