Allied Telesis AT-S63 - Manual (Page 455)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 455
Do you want to delete this table entry?(Y/N):[Yes/No]->
7. Enter Y to delete the view or N to save the view.
The following prompt is displayed:
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Access
Table Entry
This section describes how to modify parameters in an SNMPv3 Access
Table entry. For each entry in the SNMPv3 Access Table, you can modify
the following parameters:
ˆ Read View Name
ˆ Write View Name
ˆ Notify View Name
ˆ Storage Type
Configure the values of the Read View Name, Write View Name, and
Notify View Name parameters with values previously configured with the
View Name parameter in the SNMPv3 View Table. This is the only way to
associate a Group Name with these Views. See “Creating an SNMPv3
View Table Entry” on page 440.
See the following procedures:
ˆ “Modifying the Read View Name” on page 455
ˆ “Modifying the Write View Name” on page 457
ˆ “Modifying the Notify View Name” on page 459
ˆ “Modifying the Storage Type” on page 461
Modifying the Read View Name
To modify the Read View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 430. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 148 on page
431.
2. From the Configure SNMPv3 Table menu, type 4 to select Configure
SNMPv3 Access Table.
The Configure SNMPv3 Access Table is shown in Figure 153 on page
450.