Allied Telesis AT-S63 - Manual (Page 243)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 243
After you have entered a name, the following prompt is displayed:
Enter the list of switches ->
7. Enter the number (Num column in the menu) of the AT-9400 Series
switch where you want to upload the configuration file. You can specify
more than one switch at a time (for example, 2,4,5).
Note
You can upload an AT-9400 Series configuration file only onto other
AT-9400 Series switches. Do not attempt to upload the file onto any
other type of enhanced stacking switch.
The following prompt is displayed:
Do you want confirmation before downloading each switch -
> [Yes/No]
8. If you answer Yes to this prompt, the management software prompts
you with a confirmation message before uploading the file to a switch.
If you answer No, the management software does not display a
confirmation prompt.
The management software begins the upload. A switch, after receiving
the configuration file, automatically designates it as its new active boot
configuration file and resets. After the reset is complete, the switch
operates with the parameter settings in its new configuration file.
Caution
The switch does not forward network traffic during the reset. Some
network traffic may be lost.