Allied Telesis AT-S63 - Manual (Page 375)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 375
6. Modify the settings as needed. For parameter definitions, refer to
“Creating a Policy” on page 371.
When you modify a policy, note the following:
ˆ You cannot change the traffic class ID number.
ˆ To delete a value from a variable so as to leave it blank, select the
variable and then use the backspace key to delete its default value.
ˆ Specifying an invalid value for a parameter that already has a value
causes the parameter to revert to its default value.
7. Type M to select Modify Policy.
Modifications to a policy are immediately activated on the ports where
the policy is assigned.
8. To modify another policy, repeat this procedure starting with step 4.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting a Policy
To delete a policy, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 87 on page 291.
2. From the Security and Services menu, type 6 to select Quality of
Service.
The Quality of Service (QoS) menu is shown in Figure 116 on page
352.
3. From the Quality of Service (QoS) menu, type 3 to select Policy
Configuration.
The Policy Configuration menu is shown in Figure 129 on page 371.
4. From the Policy Configuration menu, type, type 3 to select Destroy
Policy.
The following prompt is displayed:
Available Policy(ies): 0-4
Enter Policy ID : [0 to 255] -> 0
5. Enter the ID number of the policy you want to delete. You can delete
only one policy at a time.
6. Type D to delete the policy.
The policy is deleted from the switch.