Allied Telesis AT-S63 - Manual (Page 830)

Chapter 36: TACACS+ and RADIUS Protocols
830 Section VIII: Management Security
Enabling or Disabling Server-based Management Authentication
To enable or disable server-based management authentication on the
switch, perform one of the following procedures.
Enabling Server-
based
Management
Authentication
To enable server-based management authentication, perform the
following procedure:
Note
Before enabling this feature on the switch, you should first configure
the TACACS+ or RADIUS settings. For instructions, go to
“Configuring TACACS+” on page 833 or “Configuring RADIUS” on
page 836.
You should not activate server-based authentication until you have
created the manager username and password combinations on the
TACACS+ or RADIUS server. Otherwise, you may not be able to
initiate future management sessions with the switch.
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Configuration menu is shown in Figure 284.
Figure 284. Authentication Configuration Menu
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Authentication Configuration
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
5 - Passwords Configuration
R - Return to Previous Menu
Enter your selection?