HP Secure Key Manager - Manual (Page 290)

Related
command(s)
• show cpiherspec
• cipherspec priority
• cipherspec
• no cipherspec
• restore cipherspec
no ssl protocol – remove the specified protocol.
Syntax
hostname (config)# no ssl protocol
Related
command(s)
• ssl protocol
• ssl-timeout
• show ssl
restore cipherspec – restore the cipherspecs to their default values.
Syntax
hostname (config)# restore cipherspec
Related
command(s)
• show cpiherspec
• cipherspec priority
• cipherspec
• no cipherspec
• no export cipherspec
show cipherspec – view the priority of all cipher on the system.
Syntax
hostname# show cipherspec
Related
command(s)
• cipherspec priority
• cipherspec
• no cipherspec
• no export cipherspec
• restore cipherspec
show ssl – view all Client-side SSL settings.
Syntax
hostname# show ssl
Related
command(s)
• ssl protocol
• ssl-timeout
• no ssl protocol
ssl protocol – enable the use of a particular SSL protocol.
Syntax
hostname (config)# ssl protocol
The valid protocols are ssl2, ssl3, and tls1. For example, you might enter the following
command:
hostname (config)# ssl protocol ssl3
Related
command(s)
• ssl-timeout
• no ssl protocol
• show ssl
ssl timeout – set the session key timeout for incoming SSL client connections to the SKM.
Syntax
hostname (config)# ssl timeout
NOTE:
The default value is 7200 seconds (2 hours).
Related
command(s)
• show ssl
• ssl protocol
• no ssl protocol
290 Using the Command Line Interface