HP Secure Key Manager - Manual (Page 132)

Table 50 LDAP User Directory Properties section components
Component Description
Server IP or Hostname The IP address or hostname of the primary LDAP server.
Server Port
The port on which the LDAP server is listening. LDAP servers typically use port 389.
For SSL connections, LDAP servers typically use port 636.
Use SSL
By default the SKM connects directly to the LDAP server over TCP. Check this box to
use SSL between the device and the LDAP server.
Trusted CA List Profile
This field allows you to select a Trusted CA List profile to use to verify that server
certificate presented by the LDAP server are signed by a CA trusted by the SKM. This
option is only valid if you are using SSL to communicate with the LDAP server.
Timeout (sec)
The number of seconds to wait for the LDAP server during connections and searches
before timing out. If the connection times out, the authorization fails.
Bind DN
The distinguished name (DN) to be used to bind to the server. The device will bind
using these credentials to perform searches for users and groups. If your LDAP server
supports anonymous searches, you may leave this field and the Bind Password field
empty.
Bind Password The password to be used to bind to the LDAP server.
Edit Click Edit to modify the properties.
Clear Click Clear to remove the current properties.
LDAP Test Click LDAP Test to test the LDAP connection after you have defined an LDAP server.
LDAP Schema Properties
The LDAP Schema Properties section describes the schema for your LDAP user directory.
Figure 71 Viewing the LDAP Schema Properties section
The following table describes the components of the LDAP Schema Properties section.
132 Using the Management Console