HP Secure Key Manager - Manual (Page 28)

11776
5. Repeat these steps with the other side rail.
Attaching rails to the appliance
1. Align one of the rails with the left side of the appliance (as you face the front of the appliance)
so that the word “FRONT” on the rail is seen right-side-up and at the front of the node.
11184
2. Align the holes in the rail with the round tabs on the side of the appliance.
3. Put the rail onto the appliance with the tabs extending into the holes on the side of the rail, then
slide the rail toward the front of the appliance until the tabs are locked into the rail.
4. Perform these steps again to install the other rail on the other side of the appliance.
Installing the appliance in the rack
1. Align the rails on the appliance with the rails in the rack.
2. Slide the appliance fully into the rack.
The rails on the appliance will lock into the rails on the rack. When fully seated against the
rack, the appliance will also lock into place.
3. With the appliance fully seated in the rack, tighten the thumbscrews just until the bezel is
secured to the rack.
Attaching the cables
1. Connect a standard Ethernet (CAT-5) cable from your local IP network (LAN) to the 10/100/1000
NIC 1 (RJ-45) connector.
WARNING!
To reduce the risk of electric shock, fire, or damage to the equipment, do not
plug telephone or telecommunications connectors into RJ-45 (NIC) connectors.
28 Installing and replacing hardware