HP Secure Key Manager - Manual (Page 227)

Figure 137 Viewing the Syslog Settings section
NOTE:
Changes to the Syslog Settings section cause the KMS Server to restart, which takes the KMS offline for
a few seconds.
The following table describes the components of the Syslog Settings section.
Table 118 Syslog Settings section components
Component Description
Log Name You can enable syslog for the all SKM logs.
Enable Syslog
If there is a check mark in the box, syslog is enabled. If there is no check mark in the
box, syslog is disabled.
Syslog Server IP
Specify a syslog server that should receive event notification messages. You can
specify a hostname or an IP address.
Syslog Server Port Specify the port the syslog server is listening on. The default is 514.
Syslog Facility The default is local1. You can choose from local0 to local7.
Edit Click Edit to modify the Syslog settings.
Log Signing
Use this section to select the logs to sign.
Figure 138 Viewing the Log Signing section
The following table describes the components of the Log Signing section.
Secure Key Manager 227