HP StoreOnce Backup - Manual (Page 98)

To edit bandwidth limiting (administrators only)
1. Display the Bandwidth Limiting Windows tab.
2. Check the General Limiting Enabled box and determine the recommended general bandwidth
limit, which is a simple calculation of:
(Max WAN Speed) x (Max Desired WAN Usage%).
Use the bandwidth limit calculator provided on this page to work out limit values, if required.
3. Click Edit to edit the Bandwidth Limiting Windows.
Configure up to two windows for each day.
Verify the appropriate Apply First/Second Restriction check boxes are checked. This ensures
the specified times are enabled. If not checked, the times are ignored. Then manually enter
the required Bandwidth Limit in each required window.
Use the bandwidth limit calculator provided on this page to work out limit values, if required.
NOTE: All settings are applied to the HP StoreOnce Backup system and not for individual
jobs. The Bandwidth Limit windows override the General Limit when the time specified for the
window is active. The General Limit applies outside of Bandwidth Limit windows.
4. Click Apply.
Fibre Channel Settings tab
If Catalyst over Fibre Channel is enabled, the Fibre Channel Settings tab is available. Catalyst
over Fibre Channel functions the same as standard Catalyst (over Ethernet). The backup application
will not perceive a difference. The Fibre Channel Settings tab is similar to the VTL Fibre Channel
Settings tab.
In the Fibre Channel Settings tab, the top section includes the Catalyst over Fibre Channel Identifier
and Identifier Alias. Click Edit to edit the alias; the Identifier cannot be changed. The alias must
begin with the “COFC-” prefix and cannot contain any special characters except a hyphen (-).
98 HP StoreOnce Catalyst functions