HP StoreOnce Backup - Manual (Page 20)

Table 4 System information parameters (continued)
Description Parameter
The IP address that provides access to the StoreOnce Management Console (GUI and
CLI) and applies to the whole cluster, not individual couplets. Cluster Management IP
The software revision of the node on which the Service Set is running. Use this when
adding couplets to check that all Service Sets are running the latest and same software. Software Revision
The Data VIF IP addresses for data. These are the addresses that you should use when
configuring backup applications to send data to the StoreOnce Backup. Data VIF IPs
If vLAN tagging has been configured on your network, there is an option to expand the
list so that you can see all the vLAN IP addresses that have been configured. For more
information about vLAN tagging, see your product’s HP StoreOnce Backup system
Installation Planning and Preparation Guide andChecklists.
Status
This section provides details about the rolled-up system status of the Service Set and the status of
the services running.
Table 5 Status parameters
Description Parameter
The state of the Service Set. Service Set Status
The status of the background support processes such as EventManager and
ResourceManager. StoreOnce Subsystem
The status of the VTL service. Virtual Tape
The status of the NAS service. NAS
The status of the StoreOnce Catalyst service. StoreOnce Catalyst
The status of the Replication service. Replication
The status of the Housekeeping service. Housekeeping
20 StoreOnce functions