HP StoreOnce Backup - Manual (Page 61)

Domain Name:
Gateway:
Default Network: no
Net Usage: data
VLAN tag:
Port Set: portSet1 with these interfaces: eth5 eth7
Encryption Links:
Bonding Mode: 1 (Active Passive Bonding)
----------------------
Network: subnet2
----------------------
IP Addresses: 172.160.20.2,172.160.20.3
Net Mask: 255.255.224.0
Domain Name: mydomain.com
Gateway: 172.160.10.2
Default Network: yes
Net Usage: mgmt
VLAN tag:
Port Set: portSet2 with these interfaces: eth0 eth2
Encryption Links:
Bonding Mode: 1 (Active Passive Bonding)
Status tab
The top part of the Replication page shows the available Service Sets. Table 13 describes the
information provided for each Service Set. Select the required Service Set to display associated
information in the tabs below.
Table 13 Replication Service Set details
The name of the Service Set. Name
The serial number of the current node. This is normally the same as the serial number of the
Main Node, unless the Backup system is in a failover state and the Service Set is unavailable. Current Node
The serial number of the main node. This is the same as the serial number of the replication
target. Main Node
The serial number of the failover node. If the Failover node and the Current Node are the
same, one of the nodes on the HP 6500 or B6200 Backup system is in an automatic failover Failover Node
state and the Service Set associated with it is from the surviving node. Replication will continue
on the failover Service Set until the problem that caused failover is resolved. There may be
some deterioration in performance, but all replication data is safe.
The replication status which may be: Replication Status
• Running
•
A target Service Set is offline
•
A mapped share (NAS) or slot pair (VTL) is not synchronized, or out of sync for a certain
number of days (hours), depending upon the settings for warning/critical out of sync
hours
Status tab 61