2 storeonce functions, Overview of the hp storeonce page – HP StoreOnce Backup User Manual
Page 17
2 StoreOnce functions
The following topics are covered in this chapter:
•
Overview of the HP StoreOnce page (page 17)
•
Select service set dialog (page 18)
•
System information and status (page 19)
NOTE:
The StoreOnce Backup system must be configured on the network.
Network configuration should only be changed under the guidance of HP Support.
Overview of the HP StoreOnce page
The initial page at GUI logon provides important information about system status and processes
that are running (see
System information and status (page 19)
).
It also provides access to individual StoreOnce functions, which are available as sub topics (click
+ to display them in the Navigator).
•
VTL (Virtual Tape Libraries) functions (page 21)
•
•
Replication functions (page 59)
•
HP StoreOnce Catalyst functions (page 90)
•
•
StoreOnce reporting (page 124)
Table 2 Service set parameters
Description
Field
The name of the Service Set.
Name
The node on which the Service Set is currently running. This is normally the same as the
Main node, unless a failover state has been invoked.
Current Node
The name of the node on which the Service Set normally runs.
Main Node
The name of the failover node for the Service Set.
Failover Node
Overview of the HP StoreOnce page
17