HP StoreOnce Backup - Manual (Page 65)

To edit or remove a Target Appliance (administrators only)
•
Select the appliance and click Edit to edit the Appliance Name, IP address, and protocol port
details of the target appliance.
•
Select the appliance and click Delete to remove an appliance from the list of Target Appliances
available to that source.
Run Traceroute
Click Run Traceroute to verify the local appliance can communicate with the target appliance and
identify the number of hops and latency in the routing.
Source Appliances tab
This tab displays the details of all source appliances.
If the HP StoreOnce Backup system also has Replication Target libraries, there may be multiple
Source Appliances.
NOTE: Source Appliances are appliances that have added the local appliance or Service Set
as a Target Appliance. Only Source Appliances currently connected to the Target Appliance are
listed.
The Source Appliances tab is not editable.
Table 16 Source appliance parameters
Source Appliance tab (no fields are editable).
The name of the Source Appliance. Appliance Name
The product class of the appliance, such as HP B6200 or HP 4430. Product Class
The virtual address of the service set. Appliance Address
The serial number of the Source Appliance. Serial Number
Indicates whether the Source Appliance is available or not. Available
The amount of data stored on the Source Appliance. User Data Stored
Shows the capacity of the Source Appliance. Capacity
Shows the amount of free space on the Source Appliance. Free Space
Shows the software version of the Source Appliance. Software Version
The day of the week and local time (in 24 hour time) of the system. The system time is set
using the CLI time commands; see the HP StoreOnce Backup System CLI Reference Guide
for details. System Time
Any blackout windows that have been specified will be reflected in this weekly calendar.
During these times, the selected Source Appliance is not available for replication. Blackout Windows
The throttling (bandwidth limiting) setting. See “Bandwidth Limiting tab” (page 69) for details. Throttling (Kbps)
Source Appliance Permissions tab
Source Appliance Permissions are disabled by default. In this state, there is no control over mapping
between share and library devices on the Target and the Source Appliances.
This tab contains an Enabled check box that, when selected, allows administrators to lock the ability
to create share and library mappings. When the Replication wizard is run and mappings are
configured, the Target will only have access to a list of sources that are allowed to replicate to it.
The tab also incorporates a wizard that becomes active when an administrator adds a new source
appliance to list, as described in the procedure below.
Partner Appliances (Replication) 65