HP StoreOnce Backup - Manual (Page 92)

•
StoreOnce Catalyst clients tab (page 95)
•
StoreOnce Catalyst blackout windows tab (page 96)
•
StoreOnce Catalyst bandwidth limiting windows tab (page 97)
Select StoreOnce Catalyst from the Navigator to display the StoreOnce Catalyst page and associated
tabs.
NOTE: Click + to expand the StoreOnce Catalyst topic in the Navigator and access the Catalyst
Stores topic.
Select the required Service Set in the top section of the page to display its StoreOnce Catalyst
settings in the lower section of the page. For more information about Service Sets, see
Select service
set dialog (page 18) .
Table 23 StoreOnce Catalyst Service Set fields
Description Field
The name of the Service Set. Name
The node on which that Service Set is currently running. Current Node
The main node for the Service Set. This is normally the same as the current node unless failover
has occurred. Main Node
The failover node for the Service Set. Failover Node
The status, which may be Running, Online, Deleting, or Fault. In the unlikely event that the
StoreOnce Catalyst Status displays as Fault, contact HP support services for further advice. Catalyst Status
IMPORTANT: When you configure StoreOnce Catalyst, the configuration applies to the selected
Service Set. All stores created on that Service Set have the same configuration settings. Each Service
Set has a Data VIF IP associated with it. This Data VIF IP is the IP address used when configuring
StoreOnce Catalyst stores as backup targets in your backup application. It is not the same as the
VIF used to log in to the StoreOnce Management Console.
The Data VIF IP for the service set is documented in the GUI for each Service Set on the Navigator
HP StoreOnce page. Select the Service Set, then look to the System Information in the bottom half
of the page. Data VIF IP provides this IP address.
92 HP StoreOnce Catalyst functions