HP StoreOnce Backup - Manual (Page 85)

NOTE: To create a new share on the target appliance, click Create New Target Share. Set
up the details as you would normally do when creating a new share. You cannot create a
new target share if the appliance to be used as the target has Replication Source Permissions
enabled.
When creating a new share, a warning indicates that it will take a few seconds for the new
share to come online. Click OK.
NOTE: The share version of the source and target NAS shares must be the same. You can
change a share from version 1 to version 2, but you cannot change from version 2 to version
1. In addition, you cannot change from version 1 to version 2 if replication mapping is in
place; you must first remove the replication mapping, ensure both the source and target devices
are on StoreOnce software version 3.11.00 or higher (upgrade if necessary), change the
source and target shares to version 2, and then reapply the replication mapping.
9. Give the Share Mapping a name and click Next.
NAS Mappings (Replication) 85