HP Insight Control Software for Linux User Manual
Page 156
•
Enter no if you want Insight Control for Linux only to manage and monitor only the servers
that you manually put in {collection_name}_Servers collection.
TIP:
Populate your collections manually before proceeding.
5.
Select Run Now.
This task can take several minutes to configure services. The Stdout tab shows the scripts that
are running, and Done appears when this task is complete.
6.
When processing is complete, select the following menu item to review the log files to determine
if the operation was successful:
Tasks & Logs
→View Task Results
7.
Select the Stdout and Stderr tabs on the tasks results screen to see more information. Review
the output in the Stdout and Stderr tabs and proceed if no errors are found.
19.4 Installing Insight Control for Linux management agents
The Insight Control for Linux management agents are deployed to all managed systems to gather
monitoring data from managed systems. Doing so enables
and
to collect data
from managed systems. This deployment is performed automatically as part of the
Options
→IC-Linux→Configure Management Services task.
If you add or remove managed systems, you need to rerun the Configure Management Services
task, which will also reinstall the management agents. Otherwise, the configuration would no
longer be valid for monitoring with Nagios.
You can deploy the Insight Control for Linux management agents manually at any time to reinstall
agents on a managed system. For example, in case the agents failed to install during the
Options
→IC-Linux→Configure Management Services task or if you reimaged a managed system
that you want to monitor.
IMPORTANT:
This task requires that HP SIM SSH keys be successfully configured on all managed
systems. For more information, see
Use the following procedure if you need to reinstall the management agents. For example, you
would need to reinstall them because you installed a new operating system on a managed system.
1.
Select the following menu item from the Insight Control user interface:
Deploy
→Deploy Drivers, Firmware and Agents→IC-Linux→Install Agents...
2.
Select the {collection_name}_Servers subcollection as the target.
3.
Select Next.
4.
When processing is complete, select the following menu item to review the log files to determine
if the operation was successful:
Tasks & Logs
→View Task Results
5.
Select the Stdout and Stderr tabs on the tasks results screen to see more information. Review
the output in the Stdout and Stderr tabs and proceed to
if no errors
are found.
19.5 Verifying successful configuration of the monitoring services
To verify successful configuration of the monitoring services, HP recommends that you perform the
following tasks:
1.
“Ensuring that Nagios is reporting status” (page 157)
2.
“Summarizing service status” (page 157)
156
Configuring monitoring services