4 changing the ip address of the cms, 5 uninstalling insight control for linux – HP Insight Control Software for Linux User Manual
Page 192
2.
Change the value of the REPOSITORY_HTTP_PORT attribute to an unused port that is available
and selected to run the repository web server.
3.
Save your changes and exit the text editor.
4.
If you have changed the port number for the repository web server, verify that the new port
is open on the CMS. One method is to use the nmap command.
5.
Restart HP SIM by running the following commands:
# /opt/mx/bin/mxstop
# /opt/mx/bin/mxstart
Wait for two to three minutes for HP SIM to restart completely.
23.3 Increasing the number of servers that can be discovered concurrently
When performing a
discovery on a set of servers, the maximum number of nodes that
are discovered concurrently is 16.
Perform the following steps to increase that number:
1.
Edit the /opt/mx/icle/icle.properties file to add the following line:
DISCOVERY_MAX_AT_ONCE=servers
Where servers is an integer value representing the number of servers discovered concurrently.
2.
Restart HP SIM.
23.4 Changing the IP address of the CMS
NOTE:
If the CMS is the DHCP server, you must edit the /etc/dhcpd.conf file to specify the
new IP address for the next-server and option-140 options.
1.
Run Deploy
→Deploy Drivers, Firmware and Agents→IC-Linux→Uninstall Agents on all your
s to remove the Insight Control for Linux management agents.
2.
Stop HP SIM:
# /opt/mx/bin/mxstop
3.
Edit the following files on your CMS and replace all occurrences of the old CMS IP address
with your new CMS IP address:
/etc/hosts
/opt/hptc/etc/sysconfig/cmsserver.ini
/opt/hp/icelx/config/iceInstallerAnswers
/opt/mx/icle/icle.properties
/etc/opt/mx/config/RootTrustList.txt
/opt/hptc/perl/lib/raapisRPCervice.pm
)
/opt/hptc/perl/lib/sim/MxpiMainService.pm
4.
4. Start HP SIM:
# /opt/mx/bin/mxstart
5.
Run Configure
→Configure or Repair Agents on all your managed systems so that snmpd.conf
is updated with the new CMS IP address.
6.
Run Options
→IC-Linux→Configure Management Services... to reconfigure the Insight Control
for Linux management services.
23.5 Uninstalling Insight Control for Linux
To uninstall Insight Control for Linux, follow this procedure:
192 Miscellaneous topics