23 miscellaneous topics, 1 changing management processor credentials – HP Insight Control Software for Linux User Manual
Page 191
23 Miscellaneous topics
This chapter addresses the following topics:
•
“Changing management processor credentials” (page 191)
•
“Changing the default port for the repository web server” (page 191)
•
“Increasing the number of servers that can be discovered concurrently” (page 192)
•
“Changing the IP address of the CMS ” (page 192)
•
“Uninstalling Insight Control for Linux” (page 192)
•
“Determining the installed Insight Control for Linux version” (page 193)
•
“Event logging overview” (page 193)
•
“Changing the number of concurrent tasks” (page 195)
•
“Support for HP ProLiant DL1xx series servers” (page 195)
•
“Setting up the DHCP server for virtual guests” (page 196)
•
“Uninstalling atftp and installing tftp” (page 196)
23.1 Changing management processor credentials
Select the following menu item from the Insight Control user interface to change the user name and
passwords for
-based management processors:
Configure
→Management Processor→Credentials
You can set these credentials at a global level for all
s or set them on an individual
basis.
If you want unique credentials on an LO100-based server, you must set them manually. The
Configure
→Management Processor→Credentials only sets these credentials locally.
For more information on management processor credentials, see
.
IMPORTANT:
Do not use multi-byte characters or the following characters in the user name and
password for iLO user accounts:
`
(back quote)
&
(ampersand)
$
(dollar sign)
<
(left angle bracket)
"
(double quote)
>
(right angle bracket)
%
(percent sign)
@
(at sign)
23.2 Changing the default port for the repository web server
By default, the
web server is configured to provide files on TCP port 60000.
NOTE:
The default port for the repository web server is hard coded in the VMware ESX Kickstart
template files. If you want to change the port, you must manually replace all occurrences of 60000
with the new port number before performing the VMware ESX installation.
To change the default port, follow these steps:
1.
Use a text editor to edit the following file:
/opt/mx/icle/icle.properties
23.1 Changing management processor credentials
191