HP StorageWorks XP10000 Disk Array - Manual (Page 99)

Figure 53 Change iSCSI name & Nickname pane
4. To change the iSCSI name, enter a new iSCSI name or select another iSCSI name in the iSCSI
name list.
To change the nickname, enter a new nickname in the Nickname box.
5. If necessary, select Apply this change to other ports, too.
If this check box is selected, the change in the pane also affects other ports. For example, suppose
the same host bus adapter (that is, the same iSCSI name) is located below ports CL1-A and CL2-A in
the tree. If you select the host bus adapter (or iSCSI name) from below one of the ports and change
the nickname to hba1, the host bus adapter below the other port is also renamed to hba1.
NOTE:
The change in the pane does not affect any port that satisfies one of the following conditions:
• The resulting nickname is already used as the nickname of a host bus adapter
connected to the iSCSI target.
• The resulting iSCSI name exists in the port.
6. Click OK. If a confirmation message appears, click OK. Changes appear in blue in the tree.
NOTE:
If you select Apply this change to other ports, too and click OK, a pane appears
( Figure 54 ) listing the host bus adapters to be changed. To make changes, click OK.
If not, click Cancel.
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
99