HP StorageWorks XP10000 Disk Array User Manual
Page 125
If you double-click an iSCSI port, iSCSI target appears as an icon. The iSCSI name appears on the
right of each icon. When
appears, the iSCSI target performs authentication of hosts. When
appears, the iSCSI target does not perform authentication of hosts. By default,
appears
for all iSCSI targets.
4.
Right-click an iSCSI target displayed with
, and select Authentication Disable -> Enable. The iSCSI
target's
icon changes to
, and the port name appears in blue.
5.
Click Apply. A confirmation message appears.
6.
Click OK. Settings are applied to the array.
To return the iSCSI target setting to
, perform the same operation, except select Authentication Enable
-> Disable in step 4.
Registering a host's user information on an iSCSI target
On an iSCSI target that performs authentication of hosts, register the user information for all hosts that
you allow to connect.
1.
Start LUN Manager, and display the Authentication pane (
).
2.
In the Port tree, select the port or iSCSI target on which you want to register a host's user information.
The user information for hosts currently registered on the selected port or iSCSI target appears
in the Authentication information (Target) list.
You can register a host's user information even if the port status is
. In this case, however, the
host's registered user information is ignored.
3.
Right-click any point in the Authentication information (Host) list, and select Add New User
Information (Host). The Add New User Information (Host) pane appears.
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
125