HP StorageWorks XP10000 Disk Array - Manual (Page 169)

b. To perform a Volume Manager operation that affects more than one SLPR or CLPR, click OK. A
confirmation pane appears. Go to step 6.
If you do not want to perform a Volume Manager operation that affects more than one SLPR or
CLPR, click Cancel. The previous pane appears, and you can retry the operation.
c. If the Set LUSE Confirmation pane appears, go to step 6.
6. Click OK (or Cancel).
NOTE:
New settings appear on the pane in blue bold italics are not yet registered to the array.
You cannot reset LUSE volumes that have been created but not yet registered to the array
(those in blue bold italics) to the state they were in before they were created (see Resetting
unregistered LUSE volumes ).
7. Click Apply (or Cancel).
8. Click OK.
Creating LUSE volumes using the LDEV information table
1. In the Volume Manager pane, select a CU number in the LDEV Information tree. The LDEV
Information table displays all LDEVs in the selected CU.
2. In the LDEV Information table, right-click the normal LDEVs, CVS volumes, or LUSE volumes you want
to form the LUSE volume, and select Set LUSE Volume.
A pane appears. If the displayed pane asks whether you want to perform a Volume Manager
operation on a volume that has a path definition (see Figure 85 ), follow step 2a. If the displayed
pane asks whether you want to perform a Volume Manager operation that affects more than one
SLPR or CLPR, follow step 2b. If the Set LUSE Confirmation pane appears, follow step 2c.
a. To perform a Volume Manager operation on a volume that has a path definition (see
Figure 85 ),
click OK. If a message appears asking whether you want to perform a Volume Manager
operation that affects more than one SLPR or CLPR, go to step 2b. If such a message does
not appear, go to step 3.
If you do not want to perform a Volume Manager operation on a volume that has a path
definition, click Cancel. The previous pane appears, and you can retry the operation.
b. To perform a Volume Manager operation that affects more than one SLPR or CLPR, click OK. A
confirmation pane appears. Go to step 3.
If you do not want to perform a Volume Manager operation that affects more than one SLPR or
CLPR, click Cancel. The previous pane appears, and you can retry the operation.
c. If the Set LUSE Confirmation pane appears, go to step 3.
3. Click OK to create the LUSE volume (or Cancel).
NOTE:
New settings appearing on the pane in blue bold italics are not yet registered to the array.
You can reset LUSE volumes that have been created but not yet registered to the array
(in blue bold italics) to the state they were in before they were created (see Resetting
unregistered LUSE volumes ).
4. Click Apply (or Cancel).
5. Click OK (or Cancel).
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
169