HP StorageWorks XP10000 Disk Array - Manual (Page 86)

Figure 38 Add New iSCSI Target pane (Option selected)
NOTE:
After you click Option, the pane expands to display a list of host mode options. The No.
column indicates option numbers. Select the check box for the option you want to specify.
7. Click OK. If a message appears, click OK. The iSCSI target name and host mode appear in blue.
8. Click Apply. A confirmation message appears.
9. Click OK. Settings are applied to the array.
Registering hosts in host groups
NOTE:
If you are configuring a NAS environment, you do not need to follow the procedures described in this
section. For instructions, see Associating host groups or iSCSI targets to logical volumes .
To set LU paths, you must register hosts in host groups. For example, if HP-UX and Windows hosts are
connected to a port, you must register the HP-UX and Windows hosts separately in two different host
groups.
If you are configuring a Fibre Channel environment, follow the instructions in
Registering hosts in host
groups (when configuring Fibre Channel environments) . If you are configuring an iSCSI environment,
follow the instructions in Registering hosts in iSCSI targets (when configuring iSCSI environments) .
Registering hosts in host groups (when configuring Fibre Channel environments)
When registering a host, you must specify the host bus adapter's WWN. If you are unsure of the host bus
adapter's WWN, see Finding an open-system host's World Wide Name (WWN) .
When registering a host, you can assign a nickname to the host bus adapter. If you assign a nickname,
you can easily identify each host bus adapter in the LUN Manager pane. Although WWNs are also
used to identify host bus adapters, the nickname you assign is more helpful because you can name host
bus adapters after the host installation site or the host owners.
86 LUN Manager operations