Delete authentication information pane, Performing mutual authentication), Specifying – HP StorageWorks XP10000 Disk Array User Manual
Page 128
Figure 73 Delete Authentication Information pane
4.
Click OK.
5.
Click Apply. A confirmation message appears.
6.
Click OK. Settings are applied to the array.
Specifying an iSCSI target's user information (when performing mutual
authentication)
To perform mutual authentication, you must specify user information for iSCSI targets on the array's ports.
Specify unique user information for each iSCSI target. You can change the specified user information for
iSCSI targets the same way you specified them initially.
1.
Start LUN Manager, and display the Authentication pane (
).
2.
In the Port tree, select the port or iSCSI target whose user information you want to specify.
The currently registered user information for the selected port or iSCSI target appears in the
Authentication information (Target) list.
3.
Right-click any point in the Authentication information (Target) list, and select Specify Authentication
Information. The Specify Authentication Information pane appears.
128
LUN Manager operations