HP StorageWorks XP10000 Disk Array - Manual (Page 184)

• LDEV Boundary: Boundary area of an LDEV number with no SSID.
• SSID: Specified SSID. The default is blank.
• Input SSID: Used to select or enter the desired SSID. You can enter the SSID only when you
log in as a storage administrator.
• SSID number of another SLPR is used: When selected, you can select the number of an SSID that
does not exist in the SLPR to which the parity group does not belong. When cleared, you can
only select the number of an SSID in the SLPR to which the parity group belongs.
NOTE:
The SSID number of another SLPR is used check box appears only when you log in as a storage
administrator and when there are two or more SLPRs.
NOTE:
You cannot enter a number in the Input SSID list when the SSID number of another SLPR is used
check box is cleared.
• Set: Sets the SSID you select or enter in the Input SSID list to the table. The Set SSID table displays
the new SSID.
• Back: Returns to Install CV pane (2).
• Next: Opens the Install CV pane (4) (confirmation pane).
• Cancel: Cancels the SSID setting, and returns to the Customized Volume pane.
Install CV pane (4)
Use this pane to confirm the settings of the CVS volumes to be created.
Figure 96 Install CV pane (4) for confirming Install CV settings
•
CVS volume setting information table: Displays a list of CVS volumes to be created.
• VDEV: VDEV number for the CVS volume to be created.
184 Custom Volume Size operations