Changing or viewing lu path settings, Deleting lu paths – HP StorageWorks XP10000 Disk Array User Manual
Page 91
Figure 43 Information about LU paths to be defined (Fibre Channel environment)
Figure 44 Information about LU paths to be defined (iSCSI environment)
5.
Click OK. Settings are shown in the LU Path table, but not applied to the array yet.
6.
Click Apply. A confirmation message appears.
7.
Click OK. Settings are applied to the array, and LU paths are defined.
Changing or viewing LU path settings
Deleting LU paths
CAUTION:
•
Do not remove LU paths when host I/O is in progress.
•
Before deleting a path to a NAS user LU, you must release the device file for the user LU if the device
file is already reserved as the copy destination of a file system. For more information about releasing
and reserving a device file, see the
NAS Backup Restore User's Guide
.
1.
Start LUN Manager. The LUN Manager pane (
or
) appears.
2.
In the tree, double-click a port. Host groups or iSCSI targets corresponding to that port appear.
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
91