HP StorageWorks XP10000 Disk Array User Manual
Page 190
NOTE:
If an LDEV number ends with # (for example, 00:01#), the LDEV is an external LU. For more
information about external LUs, see the
HP StorageWorks External Storage XP user guide
.
NOTE:
If an LDEV number ends with V (for example, 00:00V), the LDEV is a virtual volume (V-VOL). For
more information about virtual volumes, see the
HP StorageWorks Snapshot XP user guide
.
•
Select LDEV No. area: Used to set LDEV numbers for the CVS volumes you are creating.
• Select CU No.: CU number. The default is CU 00. The settings of LDEV numbers for the
selected CU number appear in the Select LDEV No. table.
• Interval: When you select more than one volume, used to set the interval between the LDEV
numbers that need to be assigned to the newly created volumes. The default value is 0. When
you select 0, consecutive LDEV numbers are assigned.
NOTE:
The value you specify as the interval between LDEV numbers counts only available LDEV numbers
and skips those that are not selectable.
• Select LDEV No. table: Displays the settings of LDEV numbers for the CU number selected
from the Select CU No. list. Gray indicates the LDEV numbers that are not selectable, white
indicates unused LDEV numbers, and blue indicates available LDEV numbers. You can select
an LDEV number from the white LDEV numbers in the table. When you set the LDEV number,
that LDEV number becomes available and changes to blue.
NOTE:
LDEV numbers that are not selectable may be already in use or already assigned to another
emulation group (grouped by 32 LDEV numbers) (see
NOTE:
If an LDEV number ends with # (for example, 00:01#), the LDEV is an external LU. For more
information about external LUs, see the
HP StorageWorks External Storage XP user guide
.
NOTE:
If an LDEV number ends with V (for example, 00:00V), the LDEV is a virtual volume (V-VOL). For
more information about virtual volumes, see the
HP StorageWorks Snapshot XP user guide
.
•
CU number of another SLPR is used: When selected, you can select the number of an LDEV that
does not exist in the SLPR to which the parity group does not belong. When cleared, you can
only select the number of an LDEV in the SLPR to which the parity group belongs.
NOTE:
The CU number of another SLPR is used check box appears only when you log in as a storage
administrator and when there are two or more SLPRs.
•
Back: Returns to Make Volume pane (1).
•
Next: Opens one of the following panes:
190
Custom Volume Size operations