Dwyer PUX - Manual (Page 79)

9 - 38
9.6.3 OUTPUT CHECK
when performing the setting of constant current output (available for loop check or to check for the
power supply output circuit of this instrument)
q Move the cursor to “OUTPUT CHECK” on the
SYSTEM CHECK page and press the ENT key.
The OUTPUT CHECK screen is displayed,
enabling you to perform the constant current
output settings.
w Move the digit by the or key, enter a
numeric value by the or key and then
press the ENT key, and the constant current
output settings can be accomplished. (range:
-20.0% to 120.0%)
9.6.4 VERSION NUMBER
To check the current version of software, move the
cursor to “VERSION NUMBER” on the SYSTEM
CHECK page and press the
ENT key.
ERROR CHECK
SYSTEM CHECK
SIGNAL CHECK
SYSTEM CHECK
OUTPUT CHECK 0.00%
VERSION NUMBER
ERROR CHECK
SYSTEM CHECK SYSTEM CHECK
SIGNAL CHECK
SYSTEM CHECK
OUTPUT CHECK 0 .00%
VERSION NUMBER
VERSION NUMBER VERSION NUMBER
PUX
Ver.5.08
(Example)
BULLETIN F-68