Dwyer PUX - Manual (Page 61)

9 - 20
9.4.2 Setting of analog output
(1) DISPLAY: when displaying present measured instantaneous flow
[Operation]
q Press the or key on the “ANALOG IN/
OUT” page and select “DISPLAY” from
“OUTPUT”.
Press the ENT key to display presently-
measured instantaneous flow.
Output = instantaneous flow
×
100/range
(2) RANGE UNIT: when setting measurement unit
q Press the or key on the “ANALOG IN/
OUT” page and select “RANGE UNIT” from
“OUTPUT”.
Press the ENT key, and the “UNIT” screen is
d i s p l a y e d , e n a b l i n g y o u t o s e l e c t t h e
measurement unit.
w Select the measurement unit by the or key
and press the ENT key.
(3) OUTPUT RANGE: when setting the range for output current
q Press the or key on the “ANALOG IN/
OUT” page and select “OUTPUT RANGE”
from “OUTPUT”.
Press the ENT key, and you are ready to adjust
output range.
w Move the digit by the or key and enter
numeric values by pressing the or key.
After entry, press the ENT key to set the range.
Example) In case of the range of 0 to 80 L/s at 4 to 20 mA
8.000 E1 (8.000
×
10)
Index is settable in range from
-9 to +9
Mantissa
Index
ANALOG IN /OUT ANALOG IN /OUT
INPUT
ANALOG
0 . 0 0 0 E 0
DISPLAY
INPUT RANGE
ADJUST
OUTPUT
RANGE UNIT
OUTPUT RANGE
OUTPUT MODE
BURN-OUT
ADJUST
m/s
HOLD
1 . 0 0 0 E 0
0 . 8 - 4 - 2 0 m A
DISPLAY DISPLAY
OUTPUT CHECK 0.00%
ESC
DISPLAY
ANALOG IN / OUT
INPUT
ANALOG
0 . 0 0 0 E 0
DISPLAY
INPUT RANGE
OUTPUT
DISPLAY
OUTPUT RANGE
OUTPUT MODE
BURN-OUT
ADJUST
m/s
HOLD
1 . 0 0 0 E 0
0 . 8 - 4 - 2 0 m A
ESC
ADJUST
ANALOG IN / OUT
INPUT
ANALOG
0 . 0 0 0 E 0
DISPLAY
INPUT RANGE
OUTPUT
DISPLAY
RANGE UNIT
OUTPUT MODE
BURN-OUT
ADJUST
L/s
HOLD
1 . 0 0 0 E 0
0 . 8 - 4 - 2 0 m A
ADJUST
m 3 / h
UNIT UNIT
m 3 / m
m 3 / s
M I / d
l / h
l / m
l / s
M m 3 / d
B B L / s
B B L / m
B B L / h
m / s m / s
M B B L / d
OUTPUT RANGE
RANGE UNIT
The “OUTPUT RANGE” initial value is 0.000E0.
Unless “OUTPUT RANGE” is set, “DISPLAY”
is 0.00%.
CAUTION
Set RANGE so that flow rate to be measured exceeds 1.2 times its maximum value.
If measured value exceeds the set value, the status display on the MEASURE screen turns “ANALOG
OUTPUT ERROR”.
Unless analog output is used, set the range at 0, and “ANALOG OUTPUT ERROR” is not displayed.
CAUTION
BULLETIN F-68