Dwyer PUX - Manual (Page 47)

9 - 6
9.1.6 TOTALIZE: when performing the integration process of
measured data (totalize)
[Operation]
Select "TOTALIZE" by the or key and press
the ENT key. The "TOTALIZE" screen will appear.
q q q q q To start integration
To open the Integration Output Selection screen, move the
cursor to “MODE” and press the
ENT key.
To set the integration output, select the integration output and
press the
ENT key.
Setting is required here when using integration output.
Mode Description
OFF
Manual
Quick timer
Integration stop
Instant integration start
Timer
Even if the timer settig is performed after scheduled start
time already passed, integration will not be carried out.
Integration starts after the time of setting, integration is
performed within the time selected from the menu, and it
stops automatically after the time passed.
Hour: minute
ENT
ENT
Set the time of integration to start and stop. Point the
cursor to "TIMER START", and then press the key.
Integration starts and stops automatically.
Point the cursor to "TIMER START", and integration will
not be started untill the key is pressed.
TIMER
END DATE / TIME
START DATE / TIME
TIMER START
01-01 00 : 00
01-01 00 : 00
QUICK
01 : : 00
00 : 30 00 : 30
02 : : 00
01 : : 30
03 : : 00
02 : : 30
SITE SETUP
MODE
TOTALIZE
MANUAL
OFF OFF
TOTALIZE
SITE SETUP
RESET DATA
MODE MODE OFF
0
UNIT m l
QUICK TIMER 00 : 30
TIMER
ESC
SITE SETUP
SITE SETUP
PIPE PARAMETER
ZERO ADJUST
RESPONSE SET
CALIBRATION
CUT OFF
TOTALIZE
0 s e c
0 . 0 0 0 m/s
--- SENSOR SPACING ---
0.0mm
PARAMETER MAMORY
MANUAL ZERO
BULLETIN F-68