Dwyer PUX - Manual (Page 24)

6 - 7
6.6 Lining material
Press the key to invert “LINING MATERIAL”.
Press the
ENT
key, and “LINING MATERIAL”
screen will appear.
Using the or key, select the material. After
selection, press the
ENT
key.
Note) If you select “OTHER”, enter the sound velocity
(range 1000 to 3700m/s). See page 15-6,
Table @1.
ENT
ENT
SITE SETUP SITE SETUP
SITE SETUP
PIPE PARAMETER PIPE PARAMETER
V
SITE NAME
OUTER DIAMETER
PIPE MATERIAL
WALL THICKNESS
LINING MATERIAL LINING MATERIAL
KIND OF FLUID
SENSOR MOUNTING
CAST IRON
1.25 m m
NO LINING
PSX2 B SENSOR TYPE
LINING THICKNESS 0.01 m m
WATER
4 TIMES TRANS. VOLTAGE
318.50 m m
SITE SETUP SITE SETUP
SITE SETUP
PIPE PARAMETER PIPE PARAMETER
SITE NAME
OUTER DIAMETER
PIPE MATERIAL PIPE MATERIAL
WALL THICKNESS
LINING MATERIAL
KIND OF FLUID
SENSOR MOUNTING
SENSOR TYPE
LINING THICKNESS
TRANS. VOLTAGE
LINING MATERIAL LINING MATERIAL
TAR EPOXY
MORTAR
RUBBER
TEFLON
PYREX GLASS
OTHER 2000 m/s
NO LINING NO LINING
PIPE NO.1
MORTAR
TAR EPOXY
ROBBER
ENT
NO LINING NO LINING
LINING MATERIAL
TAR EPOXY
ROBBER
NO LINING
MORTAR MORTAR
LINING MATERIAL LINING MATERIAL LINING MATERIAL LINING MATERIAL
Example) When the lining material is mortar
BULLETIN F-68